-
Anonymous users2024-01-23Explain that there is a gap around the upper and lower sewer pipes and that water collects here. It is advisable to remove the toilet bowl and reinstall it - it is enough to store the surrounding area with cement and sand, and then place the rubber gasket for the toilet on the sewer pipe.
-
Anonymous users2024-01-22The waterproof sealing was not done, so I found a decoration company to change it.
-
Anonymous users2024-01-21It is the toilet drain that has not been dealt with well, it should be within 1 cm above the ground, and the big workshop tips: If it is lower than the ground chain surface, the drain pipe should be waterproof, otherwise there will be this banquet situation.
The landlord is right, replace a new joint, wrap it with raw tape and install it.
1. External treatment: Seal the toilet around, the water can't get in, and it won't seep out. >>>More
This situation can only be radically cured by knocking the tiles around the pipe, cleaning up the pipe with the filler that was decorated before the decoration, and then brushing the waterproof glue, paying attention to the glue when the pipe must be painted 3-5 cm above the ground, and then backfilling with concrete to level and solidify the tiles with fine mortar cement, it is OK, although it is a little troublesome but reliable and reliable, I hope it can help you.
The solution is to find the developer to take the drawings of the hydropower direction, and then abandon the section of the estimated leakage, re-lay the pipeline, and lay the new one as long as possible to avoid the leakage point (note: be sure to read the drawings before smashing the wall, and don't throw money to break other lines). >>>More
The gap between the contact surface of the brick wall is not sealed or filled with mortar but not compact, and there are often falling off and cracks, and the flexible waterproof sealant can be filled in the groove to prevent waterproofing.