How to repair the cracks in the plastic ceiling and wall bonding?

Updated on Suspended ceilings 2024-01-27
4 answers
  1. Anonymous users2024-01-23

    There can be two solutions: one is to dismantle the old one and make a new one, which saves trouble, has good effect, high cost and long use time; The second is to remove the old ceiling all the time, re-reinforced, the replacement of the local replacement, the glue of the place to glue, this than the new do not save much work, the effect is poor, the cost may be less than the material cost of the ceiling, the use time is short, easy to deform. In short, I still recommend that you change to a new one, the cost can't be hidden.

  2. Anonymous users2024-01-22

    The plastic ceiling panel was removed from the open wall and re-fastened from above.

  3. Anonymous users2024-01-21

    Use glass glue to re-glue it.

  4. Anonymous users2024-01-20

    It is not safe for plastic ceilings to be used for a long time, so it is recommended that you can replace them with new aluminum gussets. Choose big brands, safety first.

Related questions
What's going on with cracking at the corners of the ceiling
2 answers2024-01-27

There are many reasons for cracking at the corners of the ceiling, and it is also a technical problem that is not too high! The main reasons are: 1. The stability of the plate is not good, also known as the shrinkage coefficient is too large; 2. THERE IS NO EXPANSION JOINT OR THE EXPANSION JOINT IS TOO SMALL, AND THE COMMON SEAM IS RESERVED FOR 3 5MM AS THE REFERENCE VALUE; 3. Without the elastic treatment of the seam, it is generally necessary to fill the elastic putty and seal it with kraft paper tape twice, and then do the general batch ash treatment on the surface; 4. The room is not ventilated or the temperature difference is too large, and the humidity is too large, and cracks will appear like rapid drying!

What is the cause of cracking of home improvement ceiling and how to deal with it
2 answers2024-01-27

It should be the cracking of the gypsum board joint, there are several reasons, 1, the bottom foundation is not firm when the woodworking ceiling is suspended, resulting in the gypsum board falling and cracking. 2.When the carpenter puts the plasterboard on it, the joints of the gypsum board are not placed. >>>More

How to deal with the gap between the custom-made furniture and the wall
4 answers2024-01-27

Custom furniture is factory manufacturing, on-site assembly, and the existence of gaps in the wall is a common phenomenon, many custom furniture has such a question, the. >>>More

What to do if the newly renovated walls and ceilings are cracked
8 answers2024-01-27

Wall cracking repair steps:

1. Use a putty knife to scrape out the width of the gap, and scrape the bai into a figure-eight du, which is wide on the outside and narrow on the inside. >>>More

What to do about the joints in the wall tiles and floor tiles of the bathroom, water will seep in.
14 answers2024-01-27

The caulking process should be carried out 24 hours after tiling. Before using tile grout, the cracks of the floor tiles should be cleaned32313133353236313431303231363533e58685e5aeb931333365656536, including dust, oil stains and other contaminants. At the same time, it is also necessary to remove the tile binder between the gaps in the floor tiles. >>>More