-
Anonymous users2024-01-23The description is not very clear. Under normal circumstances, the power cord diameter needs to be matched according to the total wattage of the lamp, and should not be overloaded, otherwise it is easy to cause the line to heat up unsafely. Apart from the above, said wiring didn't seem to be a big problem, but then it appeared"The spotlight is barely lit, but the top light is not lit in a large area and is flashing", I wonder if it will be that the connected live wire and zero line are not a group?
-
Anonymous users2024-01-22It's not moving, or the contact is poor, and the flash means that it is connected to the power, and it is estimated that there is a place with poor contact.
The spotlights in the ceiling of the living room are based on how many spotlights you want to place, and a light switch controls several spotlights at the same time. Therefore, the spotlights and the living room lighting, the power zero line are connected together, directly connected to the power box zero line row, and then control several spotlights according to each switch, connect the power control lines of these spotlights together, put a few spotlight control lines in a few groups, and lead them to the switch box together with the living room lighting, and add the lighting control line according to the number of control spotlight groups, and install the light switch. The thread end is generally left at 20 cm.
Are you referring to dimming ceiling lights? The kind of tricolor??? If so, it is directly connected to the neutral and live wires. Some ceiling lamps also have ground wires. Here's how the dimming mechanism works. It can be switched on and off 3 times in a row. There are 3 different color temperatures.
Of course, one route is controlled all the way, but some living room lights have a splitter, turn on one, light one, open twice, light the second. You can also install a splitter. However, it is generally not recommended, or you add carpentry to say, it is better to slotting and control line. >>>More
This way of mixing the neutral wires is wrong and will cause the leakage circuit breaker of the socket circuit circuit to trip. >>>More
It is best to divide a few more circuits in the home decoration circuit, and the zero line of each road is not shared, so that it is convenient to check the line fault in the future, even if the problem can not be found, at most there is no electricity in this way, and it will not affect the whole house without electricity. >>>More