What equipment do you need to start a small factory of custom furniture for the whole house

At present, the whole house custom processing is also divided and cooperated, there are processing cabinets, there are door panels, and the cabinets are made of cutting machines.

Edge banding machine side hole machine.

Door panel selection cutting machine.

Sanding machine laminating machine.

Painting equipment.

The processing cabinet can be made with a cutting machine, an edge banding machine, a side hole machine, a precision saw, and a blister machine will be added if the door panel is also made by yourself.

The equipment needed to open a whole house custom furniture mainly depends on your planned investment and output, and it is good to make corresponding plans after these, the following are some approximate equipment, various collocations are different, depending on your choice. A three-row drill (10,000), an edge banding machine (10,000), a sliding table saw (45 degrees: 10,000), a gong machine (10,000).

Total 10,000. A CNC cutting machine: 80,000, an edge banding machine (50,000, at this time the edge banding machine is worse than the above function), a three-row drill (10,000), total:

10,000 (this combination is a little more exceeded, the cutting is better) and some options, that is, depending on your focus, just like the edge banding machine, the cheap 4 50,000, the more expensive tens of thousands, hundreds of thousands, hundreds of thousands, hundreds of thousands, cutting is also from more than 10,000 push table saws, tens of thousands of reciprocating saws, more than 100,000 computer panel saws, hundreds of thousands of computer panel saws (after feeding or vertical and horizontal saws, etc.), drilling machines also have tens of thousands of row drills, to more than 100,000, more than 200,000 CNC drills, these all depend on your choice. For more information, please pay attention to Shunde Akun.