How to install the corner line in the integrated ceiling?

The method of forming the corner line in the ceiling is as follows:

1. Install the angle line first, and then install the keel hundred, the keel of the integrated ceiling is a fixed light steel keel, a triangular keel, there is a buckle, and the integrated ceiling can be directly buckled.

2. The triangular keel is a kind of paint keel, which is a triangular metal skeleton for construction made of high-quality continuous hot-dip galvanized strip as raw material and rolled by cold bending process. It is usually installed and used in the same way as the light steel keel, and the light steel keel is in a U shape.

3. There are also a lot of angular shapes of the integrated ceiling, which are generally simple to choose the most, and there are many patterns, according to your own preferences and styles.

4. The corner of the integrated ceiling must be at a 45-degree angle, so that it can be well accommodated.

1. The corner lines required on the four sides of the room are cut according to the actual size of the wall, which must be carried out according to the actual measurement accuracy of the size of the wall of the room.

2. Paste the corner line required by the wall below the horizontal line, align the corner line with the horizontal straight line, and mark the hole of the edge line, and the hole spacing is 10 15cm.

3. Use an electric hammer to punch a 4mm hole, the hole must be accurately marked with the cross as the center point, the hole depth is about 30cm, and there is no accurate measurement method in the process of punching, so the technology of the punching technician is required to be professional.

4. After the hole is finished, the expansion pipe is driven into the hole, and the expansion pipe shall not exceed the installation wall, so as to ensure that each step is accurate and in place.

5. According to the angle of the corner, cut the two ends of each corner line into half of the corner, the standard corner is 90, that is, the two ends of the corner line are cut to 45 degrees, and use 4 * 20 self-tapping screws to fasten and trim the corner line, and the upper mouth of the corner is aligned, pay attention to the diagonal smoothness and gap of the corner line.

6. If the corner line must be installed above the tile, the wall should be installed on the front wall of the installation corner line, the thickness of the wood strip is the same thickness as the tile, the surface of the wood strip is flush with the surface of the tile, and the installation method is the same as the installation of the corner line; Note: The corner line can also be pasted on the tile with super glue such as 502 glue when installed on the surface of the tile, so that all fixed wooden strips can be omitted.