-
Anonymous users2024-01-23There are roughly the following concentrated reasons:
1.The problem of the contact surface of the grassroots: the wall is not clean when the latex paint is applied, the workers are lazy, and the wall is not polished and cleaned, resulting in the weak adhesion of the latex paint;
2.Weather or environmental problems: During construction or use, long-term exposure to a humid environment leads to excess moisture in latex paint, and when the wind blows or the weather is dry, the latex paint will shrink and tighten, resulting in peeling.
For the former phenomenon, it is better to consult during construction, and in the latter case, for example, to brush latex paint in the bathroom, you had better choose waterproof latex paint.
3.Wall cause: Although your wall is a new wall, it does not exclude this reason, and a bad wall will also cause the surface to crack and fall off.
4.Reason for latex paint products: Don't say much about this reason, you choose not good paint, fake and shoddy products or brands with poor qualifications.
Hope it helps!
Summary. What is the treatment method for the moisture return of the bathroom wall skin: 1. If the moisture is slightly returned, you can open the window for ventilation or place some desiccant. >>>More
Hello landlord.
The door comes in front of the toilet, which is definitely not good. Moreover, the landlord's whole house is in the shape of a flat house, which is not very good for keeping money. The landlord may not like to hear this. >>>More
This is because you didn't do a good job of waterproofing before the renovation, but the ground was waterproofed, and the waterproofing around the foot of the wall was not done. Or maybe it's not done well. If I remedy, I can only smash the tiles around the bathroom and the foot of the wall on the floor. >>>More
The support is removed too early, or the stressed reinforcement is placed incorrectly (reversed). I hope my answer can help you.
Styrofoam can be used to fill the gap between the door frame of the sliding door and the entrance, and then use a wallpaper knife to remove the styrofoam, and then apply neutral glass glue to the contact area.