-
Anonymous users2024-01-23This is a quality problem of Shi Baigong
The renovation contractor should be allowed to carry out rectification.
Zhi suggested rectification method: If the DAO fruit has been paved with special tiles, it is recommended to remove the tiles, re-lay the pipes, and then paint the waterproof before pasting the tiles.
Other solutions, in the existing water outlet joint, one of the water pipes to add a straight head, the other water pipe to add a right-angle elbow after adding a straight head, this treatment can meet the use, but will affect the overall appearance, it is not recommended to operate like this.
-
Anonymous users2024-01-22Is it still bad to have hot and cold water? When it's cold, you can boil the hot water bigger, and when it's hot, you can boil the cold water more to adjust the temperature. It's easy to use. In this case, you can only install a reducer on the water valve.
-
Anonymous users2024-01-21Small question: Ah, when you buy a shower, don't you give you bent feet, is it a four-point one-end and a six-point reducer joint? The spacing can be adjusted, and it is also sold on the Internet, and it is also sold in normal hardware stores!! Check it out.
-
Anonymous users2024-01-20Remove a few bricks, and then copy and reinstall it, bathroom facilities are needed.
Bai will take a long time to du, even if it is now
If you are dealing with it well, and every time you use it in the future, it is better to solve it at one time now, and it will cost 2-3 hundred yuan, and you will definitely be able to get it. By the way, remember to make up for waterproofing. Looking for that kind of bricklayer, even waterproofing will be neat, and the province will go back and forth to find workers.
-
Anonymous users2024-01-19Find a plumber to pick up the water heater for you or you call the shop that sells the water heater, and they have workers to install it for you. Note that the shower is for adjusting the water temperature, if there is only hot water, the water boiled by the water heater is also 100 degrees, why there is a cold water pipe, you know.
-
Anonymous users2024-01-18Generally, the center distance of the mixing valve that comes with the water heater seems to be 10cm, and the current water heater adds cold water to adjust the water temperature when taking a bath at will.
The height of the water heater interface is generally between 1.5 and 1.6 meters, and the distance between the hot and cold pipes should not be too wide. I hope my answer can help you.
The back is 30 or 40, because the toilet is generally divided into 30 and 40 two specifications, and there is a 28 is the distance between the tiles and then the left and right are generally 20, the size of the toilet (some are slightly smaller), the wall is best to be the center point is more than 45, and then the total length of the toilet is about 75, it is recommended to be the most suitable for the area is a square, the best of course, according to the field situation, the unit of the number is centimeters.
If the construction hole is not properly treated, cracks will form around it. In order to prevent the occurrence of cracks, the following construction techniques should be observed in addition to the above-mentioned filling methods. >>>More
Although the price of air energy water heater is higher than that of ordinary water heaters, it is safe and completely separated from water and electricity, and the electricity consumption is also very small.
Whether the hose of the hot and cold mixing valve is broken or the connected main pipe is damaged, if it is a hose, there are threads at both ends of the hose and it can be replaced.