The toilet was blocked by a whole bar of soap, what to do, Ao was in a hurry

There are three ways to deal with a toilet clogged with a whole bar of soap:

1. Pour hot water slowly into the water surface of the toilet, do not pour hot water too quickly and carefully scald the toilet.

Three or four kettles of hot water can solve the problem.

2. Soap is alkaline, it will react when it encounters acid, pour some vinegar into the toilet, or liquids containing acid, and dissolve or melt after soap encounters acid, and then dredge.

3. Stir the wire with a hand-cranked wire for 5 minutes, then pull out the wire, check whether there is soap residue on the head of the wire, and then pull out some toilet paper and put it in the toilet bowl with a large amount of water to rinse. Special attention: the water poured into the toilet bowl cannot be flushed directly against the ceramic surface, and the water temperature is required to be from low to high.

I remember when the toilet in my house was clogged, my mom would get a full jar of water in it and leave it there. Isn't that water all gravitationally downward? If you stay for a long time, you can't stand the heavy water below.

Just go down slowly. But I thought about it again, and you're a soap. I don't know if I can do it.

I guess it's fine. And it dissolves, too. At night when you put the satisfaction jar of water in it.

Then in the morning, I don't think it should be possible. Give it a try. No way.

Let's think of something else.

It is best not to pour some corrosive chemical solvents such as sulfuric acid, which will corrode the sewer, use warm water, add some vinegar to warm water, soak for a period of time, and then buy a large toilet plucker, and you can pull it up with two more pulls.

Very simple!

Use a thick iron wire, or take a hanger for clothes, and make an iron wire to poke the soap into the flush.

Definitely OK!!

You can pour some hot boiling water, dissolve it quickly, and rinse it off, or you can get some edible vinegar, don't be too anxious, it's easy to get rid of.

Go to the supermarket and spend about 4 yuan to buy a large toilet plucker, and you can pull it up with two more strokes.

Rinse with warm water several times and do not use hot water, which can rupture the toilet. If it's not too deep, clip it out with tongs.

1. Add vinegar, preferably white vinegar.

2. Soaking with white wine can speed up its dissolution.

Pour vinegar or some toilet cleaning solution in it and rinse it with a small basin of warm water after a few minutes.

Soap is alkaline, you can use a little vinegar to speed up its dissolution, of course, it is best to pair it with hot water, which can speed up the dissolution.

Don't pour the blister, be careful that the toilet is burned! Soak in warm water and rinse several more times.

Rinse several times with lukewarm water and a little vinegar. It is advisable to be patient, and it is not enough to be hasty.

Isn't it blocked, then you can soak it in water!

You go get a bucket of super-hot water, and it's OK to pour it all at once.

Find a maintenance worker! It's easy and convenient! Otherwise, it will get worse and worse by yourself

Go to the grocery store and buy a hand-cranked dredge to do it yourself.

Soak it in boiling water and it will melt away.

How did it work in the end? My family is like this, I don't know what will work faster.