I beg for details on the solid wood door veneer method, thank you

There are currently 2 types of skins on the market 1: self-adhesive 2: thin skin not closed is such a skin The first is the pre-treatment of your door :

Scrape the ash (with a small amount of water with blended paint and plaster) and wait for the ash to dry and polish the fine sandpaper below 220. Remove ash . Cut the paper as needed (1CM larger than your size [note the direction of the wood grain on the paper]) and run the thin skin paper through the water.

The carpenter brushes the door with white glue on the paper to be pasted, there should be water on the paper, but not more, two people hold the paper and put it gently, pay attention to 1 person to put it first, and then use a leather scraper to scrape left and right to exhaust the air until teammates can let go.

Those who understand are difficult to say and easy to do, and those who don't understand are difficult to do and easy to say, and it is recommended that you find someone who understands to help you The wage is not high.

1. Technological process: high-quality Russian imported camphor pine large-diameter round wood is used for processing, which has the advantages of light color and clear texture;

2. The use of high-temperature steam fumigation after 15-20 days of oil desizing treatment, remove the oil and other impurities in the plate, so that the final water content is 8% 12%, reaching the international standard.

3. Material selection finger jointing: Break the board into a specification square, remove the impurities such as knots and oil bladder color difference boards, select the high-quality wood, and bond them together with finger jointing technology and imported environmental protection adhesives to form an integrated slab, which is a stress joint formed inside the board, which will not crack and not deform.

Clean the surface and apply white latex; Veneer; A few needle nails on the surface OK!