-
Anonymous users2024-01-23Enter REC to draw an 860*430 rectangular rectangle, then enter the X command to decompose the rectangular rectangle mirror, select the bottom line of the rectangular rectangle, and then enter O to offset 80 units inward, the result is shown in the figure.
Then enter the shortcut key C to start drawing circles, here you need to draw five concentric circles, the radius of the five circles is 20, 30, 50, 100, 120 respectively. As shown in Fig. When drawing concentric circles, you can use the method of snapping the center of the circle on the one hand, and you can also draw it with the offset command on the other hand.
Enter REC to draw a small 12*65 rectangular rectangle, place it on top of two large circles, as shown in the figure, and then enter the AR shortcut key to make the matrix, we select the polar axis PO mode, then select the center of the circle, enter the number 4, and finally the effect as shown in the figure appears.
Enter the RO selection shortcut, rotate all five circles and four rectangles at an angle of 45 degrees, and then enter TR to start trimming and trimming out the unwanted lines.
Enter the C shortcut key to draw a small circle with a radius of 22, then enter REC to draw a 15*60 right-angled rectangle, and then move the right-angled rectangle to the middle of the small circle, enter TR, trim it, and trim it to look like the figure, this is the switch of the gas stove.
Enter REC, draw a rounded rectangle of 110*180 with rounded corners of 20, and then place it between the two stove cores, as shown in the figure, and save it to complete the whole gas stove.
-
Anonymous users2024-01-22600 wide, the length is customized, put a basin and gas stove on it. The meaning is on the line, and I am really ready to draw the detailed plan of the stove That's not exhausting people.
-
Anonymous users2024-01-21Drawing or designing?
If there is a real thing, please send a photo.
If there is no physical matter, please give it a score first.
-
Anonymous users2024-01-20Just install a TENGEN software and plug it in directly.
-
Anonymous users2024-01-19Kitchen cabinets are close to about 600 If it is a cooking stove, you only need to call the CAD module.
The floor plan should be drawn with depth lines. It's the hatch. Then there is a detailed drawing of the gypsum board ceiling. It is best to have sections, elevations.
I'll teach you that the size is not easy to say, they are all ordered according to the actual situation, but some of them are fixed, wooden edges, desk heights, partitions, toilets from the drainage, TV backgrounds, wardrobes, etc., all have fixed sizes, but they are generally positioned according to the indicators of the scene, and they are not fixed.
As for the drawing method of the power outlet switch in the floor plan, it is explained in the design atlas standard, as shown in the figure below.
First define the "up and down" of the "kitchen stove" you refer to, and the "stove (countertop)" is the datum to divide the upper and lower "countertops": position, washing basin, press 1 socket, use the hot water faucet;Location, cupboard basket, press 1 socket, use disinfection cabinet, note that some gas meters are not allowed to install sockets in the position of the washing basin. >>>More
Feng Shui believes that the kitchen is based on wood and fire, or water and fire. The five colors are blue, red, yellow, white and black, corresponding to wood, fire, earth, gold and water. Kitchen stoves and cabinets, stoves are the mainstay, cabinets are supplemented, and the color matching should avoid white (gold) red (fire), white (gold) green (wood), yellow (earth) black (water), green (wood) yellow (earth) and so on. >>>More