What should I do if the glass sliding door in the kitchen won t move

The glass door cannot be pushed because the lower end of the roller is worn out, and the glass door needs to be removed and replaced with new rollers. Tools required: utility knife, screwdriver, two new wheels, vise. Here's how:

1. Push the glass door up and take it out obliquely.

2. Use a screwdriver to rotate the screws on both sides of the low end of the glass door.

3. Then use a utility knife to cut the glass glue along the low end, and the front and back sides should be cut.

4. Then use the vise to remove the bottom frame little by little.

5. Pour out the worn rollers in the bottom frame.

6. Install the new rollers, a total of two, and then screw the screws in the original way, and install them back into the glass door at an angle.

Sliding doors work similarly to train tracks. There will be a metal track on the ground. There are two wheels inside the glass door, and the wheels are stuck on the track for easy pushing and pulling when installed. Therefore, there are several reasons why the push and pull cannot be moved:

The wheels are off the rails, causing the glass door to rub directly against the track, in which case the glass door is lifted and the wheels are re-stuck on the track.

The wheels are damaged because the glass door is heavy, which can easily cause the wheels to crush and deform. Or the wheels don't rotate smoothly due to garbage silting. This requires a new wheel replacement.

The track is deformed, so that the wheels cannot roll freely and briskly on the track. This requires adjusting the track to a straight one.

There are two possibilities, one is that the pulley has fallen off the rails, which is simple, and it is enough to lift the door leaf by hand to reset, which is a common problem; Then there is the breakage of the pulley, which needs to be replaced.

The sliding door takes up less space, is properly maintained, and is easy to use. The sliding door does not move, the cause of abnormal noise and the solution.

1) Reason: mainly the lubrication and rust prevention of the slideway and the small wheel,.。

2) Use lubricating materials: to use sliding door wheel rail grease, Senge and other well-known sliding door brands use tiger head hotolube or Kruber sliding door wheel rail grease. Colorless and odorless, with good durability and safety certification.

There are 130 grams of small tubes in the hedge, which is easy to use. The maintenance interval is half a year.

3) Coating method: First of all, clean the slideway carefully, apply the grease into the slideway and pulley, pull the door several times, the grease will penetrate into the slide and the bearing, and then pull it is very smooth.