How to solve the problem of toilet flushing and no whirlpool

Toilet flushing slowly, powerless, no whirlpool? Move this small mechanism in the water tank, easy to solve, practical.

Toilet flushing powerless no whirlpool solution:

1. If the amount of water in the water tank decreases, the toilet flush will be weak and there will be no whirlpool. If it is a top-press toilet, mainly because the length of the pressure rod changes, resulting in the water stop pad quickly reset to stop the water, as long as the water tank cover is opened, reversed, loosened the pressure rod nut, and adjust the length of the pressure bar to the appropriate one.

2. The water level of the inlet valve is low, resulting in weak water outlet. The specific solution is to remove the inlet valve, remove the inlet valve buckle, turn the inlet valve body counterclockwise, then adjust the height of the body accordingly, and finally rotate the inlet valve body clockwise. Install the buckle, install the water inlet valve, connect the filter and the water inlet pipe, and the fault will be solved.

3. When the toilet is weak and there is no whirlpool, if you see a lot of dirt at the toilet outlet, you can use some baking soda or white vinegar to clean it, which will not hurt the ceramic glaze of the toilet bowl and can be quickly restored.

There are two common reasons why the toilet is not flushing:

1.The side handle chain of the side-press and side-wrench toilets is long, which causes the water-stopping pad to stop the water quickly, although it moves. Workaround:

Please shorten it to an appropriate size. Or the top press bar of the top press toilet is low, resulting in the water stop pad moving but quickly stopping the water. Workaround:

Open the water tank cover, reverse, loosen the nut of the pressure bar, and adjust the length of the pressure bar to the appropriate one.

2.The water level of the inlet valve is low, resulting in weak water outlet.

The solution is to remove the inlet valve and remove the inlet valve buckle. Turn the inlet valve body counterclockwise. Then increase the height of the body accordingly.

Then rotate the inlet valve body clockwise and attach the buckle. Finally, install the inlet valve. Connect the filter and water inlet pipe, and the fault can be eliminated.

Ceramic staining: The ceramic glaze of the toilet bowl is not smooth enough, which is easy to hang dirt, and it will also cause the flushing to be unclean.

1. If there has been a similar situation, it is a product quality problem and the glaze material is not good, so let the merchant come to deal with it.

2. In the past, it could be cleaned, but now if it can't be cleaned, clean it frequently, and don't use too corrosive washing liquid, which will damage the ceramic glaze and make it easier to hang dirt in the future.

Ceramic hanging dirt solution:

In general, it is good to brush directly with a toilet brush. If it is always easy to get dirty, a good toilet with ceramic glaze is better, use cheap toothpaste, be careful to be white, not the transparent kind, and then scrub with the green or blue rough side commonly used for dishwashing. If you haven't cleaned it for too long, you can use a steel wool ball to gently wipe it first.

However, the use of steel wool balls and decontamination powder will damage the ceramic glaze, so it is recommended not to use it.

If you've tried unblocking and it still doesn't solve the problem, then it's easy to do. There is a small round hole in the toilet drain, and the problem is solved by unclogging this small round hole, and this is how my toilet pumping power is solved.

Replace the inlet pipe, it's all rust inside.

Dismantle and replace the thick pipe toilet with a flood function.

Toilet flushing slowly, powerless, no whirlpool?