How to fix the toilet tank keeps leaking

The toilet tank keeps leaking, teach you a trick to solve it quickly!

As the flange ring ages, it hardens, resulting in a decrease in the sealing effect, which in turn causes the toilet to leak. We just need to lift the toilet bowl and replace it with a new flange ring, and we can solve the problem. When buying a new flange ring, pay attention to the quality of the flange ring:

The thicker and softer it is, the better the quality.

It is not a problem for normal flange rings to be used for more than ten years, and the reason why they age so quickly is that the sealing of the toilet rim has deteriorated. When a large amount of dry air comes into contact with the flange ring, it will accelerate the aging rate of the flange ring.

Where the toilet bowl is in contact with the floor, it needs to be sealed with glass glue. So after replacing the flange ring, remember to re-apply the glass glue. And usually observe this circle of glue, if there is a leakage of glue, it should be repaired immediately.

Take down the water piece in the tank, that is, the water inlet, take it apart, and clean the rubber inside, because it has not been cleaned for a long time, and there is too much scale.

Reasons why the flush toilet tank keeps flowing:

1.Water tank material problem: The water tank material is not good or the internal parts of the water tank are old.

2.Toilet drain problems: The toilet drain pipe is a pipe that transports water mainly connected to the toilet tank, and there is a high possibility of problems here.

3.Toilet drain valve problem: The toilet drain valve is in charge of the water in the toilet tank. The flush toilet tank keeps flowing all the time, which may be caused by cracking and deformation of the installation hole, or uneven and uneven installation surfaces and carelessness during installation.

The solution to the flush toilet tank that keeps running water:

1.For the problem of the material of the water tank, you can separate the toilet tank and check it one by one to see whether the parts in the toilet tank are in good condition.

2.For problems with toilet drain pipes, you can carefully check whether the toilet and sewer interface are loose, or the pipes are rotten. If the pipe is rotten, it needs to be replaced; If the toilet is loose at the sewer connection, you need to re-use some material to fix it.

3.For the problem of the drain valve of the toilet, it is recommended to ask the worker who repairs the toilet to carry out professional maintenance as much as possible, so as to ensure the normal use of the toilet.

Crack your toilet with a hammer and replace it with a new one. Hehe.