-
Anonymous users2024-01-23The general procedure is:
1.Close the angle valve under the toilet tank (some people call it the "figure-eight door");
2.Drain the toilet tank with water;
3.Remove the snakeskin hose from the water inlet of the tank;
4.Unscrew the cap clockwise from the bottom of the tank inlet and the inlet valve can be removed from the tank.
The structure of the tank is varied, and you'd better spend a little money to hire a plumber to help. Otherwise, it may be dismantled, cleaned up, and you can't install it!
-
Anonymous users2024-01-22Hello everyone, so far, I have found a correct answer to this question, please check the following URL, Solve the problem of the toilet fill valve top cover squeaky water, but the hose does not come out of the water.
The principle of toilet water supply is:
1. Use the float to control the water intake, when the water is full, the float floats up and pulls the connecting rod to close the water inlet, and the water stops. >>>More
The working principle of the toilet inlet valve is to use the buoyancy of the water, the principle of lever, when the water is discharged, the float weight opens the valve, the water is in, when the water is discharged, the water seal falls completely, and the float is raised to close the valve upward after the water is inlet to control the water inlet of the water tank.
The construction principle of the water valve in the toilet tank: there is a float in each automatic flushing toilet, as the water level in the toilet rises, the buoyancy generated by the float is getting bigger and bigger, when the water level rises to a predetermined value, the buoyancy generated by the float will be transmitted to the switch through a seesaw structure, the switch is closed and then the water inlet valve will not enter the water, when the water is discharged, the button or wrench pulls the plug of the water discharge, and the plug is automatically pulled out. After the water is discharged, the plug automatically returns to its position under the action of the spring and enters the next round of water filling cycle.
If the toilet was originally unblocked, now this is the case, you don't want to dismantle the toilet first, you first go to the people below, negotiate with them, open the toilet water storage elbow above the ceiling of his bathroom, this place may have straw paper or something to block, if there is nothing in the water storage bend, please dredge a professional to dredge this level of pipe, I think it will definitely solve the problem, if this can not be solved, you ask a plumber master to remove the toilet, do not dismantle it yourself, the foot is easy to break. I hope you find my answer helpful.
It is estimated that the toilet is clogged, first dredge it yourself, if it is not easy to use, find a professional to dredge the toilet, if it is because of a long time, the toilet is aging, then it is better to replace it with a new one!!