-
Anonymous users2024-01-23The differences between metal checkered ceilings and aluminum grid ceilings are:
1.Metal checkered ceiling: the metal surface is 30mm wide, 50mm high, and the spacing is 60mm. The thickness of the plate depends on the size of the plate, but the minimum shall not be less.
Perforated aluminium sheet: Metal finish shade Sparkling
irondrak, open porosity 20%.
2.Aluminium grating ceilings are available in 10mm or 15mm as standard, with heights of 80mm, 40mm and 60mm. Aluminium grille lattice sizes are available in 200x200 mm, 150x150 mm, 125x125 mm, 100x100 mm, 75x75 mm, 50x50 mm. The conventional grid size of the sheet grille is (mm *60;
The standard standard of conventional aluminum grille (upward viewed glossy surface) is 15mm or 10mm, and the height is 80mm, 40mm, 60mm and 20mm;
Among the common materials in the grille ceiling, the better material is the aluminum grille ceiling. Aluminum grille ceilings are divided into special-shaped grille ceilings and grille ceiling series. The special-shaped grille has obvious artistic effects, strong sense of fashion, light material and simple appearance.
The ceiling made of aluminum grille can be combined in a divided grid, and no connector is required for installation.
-
Anonymous users2024-01-22Aluminum grille ceiling is not much different from ordinary ceiling, but in the installation process, the general is some light-colored grille, and the installer must be required to wear clean white gloves to prevent dirtiness. The grating ceiling is ordinary, after the boom is laid, the lower 38 main keel, after leveling, the assembled grille paddle is fixed on the 38 main keel with hanging pieces, and then slightly leveled after the completion of the OK. The grille is generally lap connected, so the general purchase of materials should be a certain amount of wealth, 1000 square meters of the grid to play out of 30 square surplus volume.
At present, the mainstream of the domestic market is divided into two kinds of flat bottom grille and groove grille, some other special-shaped grilles are not mentioned, replenishment is also very troublesome, only say that groove grilles and flat bottom grilles, the installation of workers and masters know that groove grilles are better than flat bottom grilles to install more, and the loss is much smaller, an installer can install 10 square meters of flat bottom grille ceilings on average an hour, then the same time to install groove grilles can reach 20 square meters. If 100 square meters of construction site needs a flat bottom grille to 130 square meters, it is almost practical, if you use a groove grille, it will be enough to use 110 square meters.
The price of aluminum grating material varies from a few yuan to dozens of yuan per square meter; >>>More
Aluminum square grille ceilings are more expensive, and raw materials are more expensive. Ecological wood ceilings are made of wood powder and other additives, and the cost is naturally lower.
The grid lamp is a kind of illumination lamp, and the price of T5 grid lamp is not expensive. It is suitable for installation in the writing room with DU ceiling. The light source DAO is generally a fluorescent tube. It is divided into built-in and in-ceiling. >>>More
The plastering surface and the ceiling keel are blackened, and there is no light reflected out, so the ceiling keel is not visible from the outside.
No, the two are about the same, mainly because gyplight is an ordinary ceiling material, but it is expensive to do modeling! The grille is also an ordinary ceiling material, and the keel is less than gypsum board. But I can't do styling. (This question is answered by Nanjing Zhongxin Beilong Building Materials). >>>More