The bathroom of the old house seeps water downstairs, please ask how to deal with it

Updated on Bathroom 2024-01-28
7 answers
  1. Anonymous users2024-01-23

    Look at whether the outer layer is leaking or the inner layer, the outer layer can be strengthened with some waterproofing to fill the leaking gaps, and there are many transparent brushes that have little impact on the floor. The inner layer was only dug up and redone.

  2. Anonymous users2024-01-22

    How to deal with water seepage downstairs in the bathroom of the old house? I think the bathroom is leaking, and the bathroom should be redone to waterproof, and that's fine.

  3. Anonymous users2024-01-21

    It is recommended to re-do a waterproof.

  4. Anonymous users2024-01-20

    If you can fill the leak, find an experienced master to do it, the key is to find the leakage point. It should also be noted that it is not necessarily the ground leakage, the wall, the interface of sanitary appliances is also easy to leak, if it is not done, I have to remove the bricks. If the face tile is not very advanced, simply remove it, even take off the redo waterproof and then paste it for a whole day, hehe, bathroom leakage is the most headache.

  5. Anonymous users2024-01-19

    Hello, you have to knock out all the floor tiles in this bathroom, and then re-pour the concrete, and then do the waterproofing, waterproof foam for three days, no leakage, and then redecorate.

  6. Anonymous users2024-01-18

    How to deal with bathroom leakage downstairs, bathroom leakage without smashing bricks The key to maintenance methods is to save money.

  7. Anonymous users2024-01-17

    1. There is a leakage at the buried water pipe joint or the exposed water pipe joint in the bathroom. In this case, for open pipes, you can check by visual observation, and for dark pipes, do a pressure test to see if there is a leakage in the water pipe.

    2. The open water in the bathroom, such as showers, leaks downstairs.

    3. After determining the cause of water leakage, look for leakage points, which are mainly through the observation of the top of the bathroom downstairs to find leakage points.

    4. Smash open the corresponding part of the ground tile corresponding to the leakage point for maintenance.

    5. Use the leak plugging spirit to deal with the leakage area and its surroundings.

    6. The above method is an indicator method, which is relatively time-saving and cost-saving. After the treatment is completed, a closed water test is done to observe whether there is a leakage problem downstairs.

Related questions
1 answers2024-01-28

Check the cause first and see where the leak is, the general kitchen is not waterproof. Find the reason in looking.

7 answers2024-01-28

If you don't want to dig tiles and redo waterproofing, you have to find an easy way. >>>More

2 answers2024-01-28

It is not recommended to construct from downstairs, and it is not recommended to use grouting waterproofing for backwater construction from downstairs construction, and it is not recommended to use it to treat the symptoms but not the root cause; >>>More

3 answers2024-01-28

First of all, determine whether the wall seam seepage goes down, and to understand whether the bathroom is sunken, whether the waterproofing of the bottom plate below has been done, you can first use epoxy seam glue caulking to see the effect, if it is a small area of water seepage of a single-layer prefabricated board, you can also use UD001 high-strength special impermeable material on the ceiling roof downstairs to do the backwater surface impermeability, and the specific implementation requires a professional waterproof plugging master.

1 answers2024-01-28

It's okay, because the cracks are unimpeded when the tiles are opened, so the watermark is big, and I will look at it every two or three days after doing waterproofing, and there should be no more water seepage, if the water seeps again, it is not good to be waterproof.