How to install European style solid wood lines

Updated on Solid wood 2024-01-27
2 answers
  1. Anonymous users2024-01-23

    Installation method of molding:

    1. Construction tool saw blades, hand saws, tape measures, angle rulers, trowels, wallpaper knives, 2m rulers, gray knives, wire brushes, ink fountains, hammers, and steel nails.

    Second, the construction technology on the flatness of the construction wall requirements: with a 2m ruler against the wall requires a deviation of less than 5mm.

    1. Other construction procedures such as walls, window and door openings have been completed and accepted.

    1) Grassroots cleanup.

    Clean up the floating ash, release agent, oil and other debris remaining on the concrete wall, as well as the plastering hollow parts.

    Remove the cracked concrete blocks, inclusions, hollows, etc. at the wall joints, and repair them again; The window sill eaves are found with cement mortar according to 2, and various openings in the outer wall are filled densely.

    It is required that the surface flatness deviation of the polystyrene board should not exceed 5mm, and the protruding wall should be polished when the deviation is exceeded, and the recessed part should be repaired (1:3 cement mortar should be used to plaster when the thickness of the polystyrene board needs to be repaired is less than 6mm, and the insulation construction unit shall use polymer adhesive mortar to make up when the thickness of the repair is less than 6mm); In order to ensure that the flatness of the whole wall is within 5 mm, the yin and yang corners are square, and the top and bottom are smooth.

    2) Prepare mortar.

    The mortar used in construction is divided into special adhesive mortar and surface polymer anti-crack mortar.

    During construction, the mass ratio of the bonded mortar mixed with a hand-held electric mixer is water: mortar = 1:5, stirring while adding water; The stirring time is 5 min, and the stirring must be sufficient, uniform, with moderate consistency and certain viscosity.

    After the mortar is prepared, it must be allowed to stand for 5min, stir again before use, and the mixed mortar should be used up within 1h.

  2. Anonymous users2024-01-22

    There is a glue for sticking lines, construction glue, which is very powerful, and it will not fall off when glued.

Related questions
How to calculate the price of oak solid wood lines
1 answers2024-01-27

The price per meter of wood moulding is obtained by multiplying the volume of oak wood per meter (plus loss) by the volume unit price of oak timber (including processing costs).

Is it necessary to install solid wood moldings for solid wood doors
6 answers2024-01-27

The lines must be installed, except for the closing problem, it is that way to have a more overall effect, and it looks more coordinated! In one is, if you choose a wooden door, it should be a fancy to his grade, if there is no line, it is difficult to set off his grade! However, the choice of wooden doors is very knowledgeable, you have to be careful not to be fooled by dealers, and there are some domestic louder brands, he is also cheap. >>>More

There are several specifications for the decoration of solid wood lines
2 answers2024-01-27

The general public specifications are 4 6 8 10 12 15 cm.

How to fix solid wood moldings to the wall
4 answers2024-01-27

Generally, it is fixed with an electric hammer to drill the hole gun nail, and now there is a kind of ST gun nail, which does not need to be embedded with a wooden plug, and is directly nailed to the wall, which is simpler and more trouble-free.

What manufacturer to choose when buying solid wood lines
1 answers2024-01-27

Solid wood line selection criteria:

1. The surface should be smooth without pits and damage. >>>More