Can a gas water heater be installed in a kitchen wall cabinet?

No, you cannot. Gas water heaters should be installed in places that can be ventilated, gas combustion to produce exhaust gases, if not completely burned may also produce carbon monoxide and other toxic gases, if poor ventilation may be dangerous.

No, because it's going to be repaired, and in case of a leak, the alarm can't be found, because the gas is going up, and we're usually going to install it in a base cabinet.

Yes, pay attention to the heat protection of ventilation and exhaust.

How gas water heaters work. Gas combustion is used to heat tap water. Heating.

And if it is installed in a wall cabinet, according to national regulations, it should be considered that the gas water heater burns sufficiently. Because of insufficient combustion, carbon monoxide is easily produced, resulting in gas poisoning.

In the specific operation process, it is more beautiful to install in the wall cabinet. Taking into account the problem of sufficient combustion. In addition to the air intake holes, shutters can also be used to install air intake channels. Burn sufficiently. Aesthetic achievement.

Hope it helps.

No, because carbon monoxide is excreted, and carbon monoxide binds hemoglobin, and you know the consequences of binding, and it can also contaminate certain foods

Answer dear, I have received your question, I will reply in time after reading, please wait a while. After you ask, because there are too many lists, they will answer in turn, and they will not fail to answer you, please wait patiently for a while!

No, the gas water heater must be installed in an open place and cannot be blocked by other things.

Gas water heaters also cannot be installed in bathrooms, living rooms, bedrooms, and basements. And it should also be more than one meter away from the open flame, otherwise it will also cause damage to the water heater. Gas pipelines must be exposed and cannot be wrapped, and it is absolutely not possible to block gas pipelines with aluminum gusset ceilings.

Hello, my answer has been sent out, I hope my answer can help you, please have any other questions I can help you! You can ask it within 24 hours, and I will help you analyze and answer. If there is no problem, please help me like it in the lower left corner of "I want to evaluate", thank you.

Have a great day! Good luck always accompanies you. ❤️

Question: The installer said yes, he said that the intake air absorbs the outside air through the flue.

Question: I think heat dissipation is also a problem. But the professional installer said it was no problem.

No, it is best not to do that because it may affect the full combustion of the gas and thus the safety of the gas.

Yes, the lower part of the wall cabinet should have air inlet holes, the exhaust pipe of the water heater should be connected to the outside, and the wall cabinet must be all made of fireproof boards.

The walls are lined up.

Inline can't be used.

No, the natural gas company has regulations, the natural gas pipeline and the related exhaust pipe must be open pipes, can not do concealed engineering, and the exhaust pipe of the gas water heater is to go to the outside, the distance is as small as possible, generally can not exceed 3 meters

No, any water heater must be installed separately and at a safe distance from other items for the reason: to ensure the safety of you and your family.

It cannot be installed in a wall cabinet, which is very unsafe. It is easy to cause a fire or deform the wall cabinet.

As long as it is a water heater with strong exhaust air, it can be installed in the kitchen wall cabinet.

No, it is easy to catch fire and get poisoned by gas.

No, you can!Safety first.

You can hang the cabinet and install the shutter door! It's airy and beautiful!!

You can do a good job of ventilation ducts.

It can be installed, but the door panel must be a hollow or louvered door, but the top panel of your cabinet must also have holes to dissipate heat! Prevent air leaks!

To be on the safe side, don't pretend like this, the temperature is too high!

It's not safe and there's not enough oxygen in it.

No, you can!Not even for the sake of aesthetics.

During the installation and use of the gas water heater, it is necessary to ensure that the ventilation around the gas water heater is smooth and there are no combustibles, and installing it in the wall cabinet or in the middle of the wall cabinet will lead to the anoxic operation of the gas water heater, that is, the gas water heater will not burn sufficiently, which will produce a large amount of carbon monoxide, resulting in an increase in the carbon monoxide content in the room and endangering personal safety; And the vast majority of the wall cabinets themselves are combustible, and if they are too close to the gas water heater, there will be great safety hazards.

There are two very important requirements for the installation of gas water heaters:

1. Keep away from combustibles, at least 1 meter away;

2. There should be no shelter around the perimeter, and the distance from the shelter should be at least 50cm or more to ensure that the gas water heater is well ventilated and can be fully burned.

1.Punching: Before punching, the master should first take a measurement, and then punch the hole on the wall according to the measured data.

The storage water heater must be installed on the load-bearing wall, otherwise there are potential safety hazards, if it has to be installed on the light wall, it must be installed below the bracket or other treatment. It is also a skill to drill holes in the tiles, first use a fine drill bit to grind a small hole to fix the hole position, and then use a thick drill bit to slowly grind the tiles through with a slow gear, and then use the impact gear to drill the hole deeply, so that the general tile will not crack.

2.Hang the gas water heater: drill a dozen, fix the screws, and then hang the gas water heater.

At the same time, it is necessary to ensure that the water heater is firm and not loose. The installation height is generally 165 175 cm, and the fire window is parallel to the person's line of sight. After fixing the water heater, it is necessary to fix its hot and cold triangle valves.

It should be noted that the outlet pipe (hot water) should not be equipped with a valve, otherwise it will affect the water output and affect the use function.

3.Exhaust pipe and threaded pipe installation: connect the reserved cold water pipe to the water heater.

To choose the right water pipe to connect the reserved cold water pipe with the water heater, you can generally use a special metal hose and choose a water pipe that is not easy to age. At the same time, don't ignore the installation of small details, the installation of exhaust pipes and threaded pipes is equally important. The exhaust gas exhaust hole of the water heater should be opened separately, and the public exhaust hole should not be used.

After the installation is completed, the overall test should be carried out, and the gas should be turned on, the electricity should be turned on, and the test should be carried out to test the heating function of the water heater and whether the water pipe is leaking. After that, it is necessary to test the pressure and carry out the compactness test to ensure the safety of use.

It is best not to put it in a wall cabinet, the gas water heater should be ventilated, and it is not safe to put it inside.

And he still has a temperature. That's wood, so it's best not to let it go.

Do not put flammable objects in the wall cabinet! Gas water heater ventilation.

It is okay not to leave the cabinet door open when in use.