How many meters outside the balcony is considered a safe width?

Updated on Balcony 2024-01-28
3 answers
  1. Anonymous users2024-01-23

    1.Rules for calculating the floor area of the outward balcony on the residential floor: if it is a fully enclosed balcony, the area should be calculated according to the horizontal projection of its periphery. The unenclosed balcony is calculated according to 1 2 of the horizontal projection area of the periphery of its enclosure;

    2.The safe width of the balcony overhang: under normal circumstances, it is less than 2 meters, and more than 2 meters needs to be supported by columns;

    3.The renovation of old houses generally cannot be done with external balconies, because it is not safe.

    Note: balcony pick reinforcement skills, the safe width of the outer beam.

    Cantilever 2 meters of balcony, cantilever beam 250 * 400 reinforcement: upper 3-diameter 25 steel bars, protruding into the side wall beam or frame beam 2 meters; The lower part of 2-diameter 16 is made of erection ribs, the diameter of the steel hoop is 10, and the spacing is 150mm. A cantilever plate is a cantilever plate that has no direct vertical support under the slab, and relies on the slab itself, or a cantilever beam under the slab to bear (transfer) the vertical load.

    The cantilevered plate is a structure in which the upper part is tensiled. A balcony, also known as a balcony or balcony, is a platform that protrudes from the outer wall of a building and is supported by columns or brackets, and its edges are built with railings to prevent objects and people from falling out of the platform range, which is an extension of the building. Although a balcony and a balcony refer to the same kind of building, there are some slight differences between the two, a platform without a roof and no cover is called a balcony, and a platform with a cover is called a balcony.

    Balconies are an extension of the interior of a building, a place for occupants to breathe fresh air, dry laundry, and place potted plants, and their design needs to be both practical and aesthetically pleasing. The balcony is a place for residents to receive sunlight, absorb fresh air, exercise outdoors, watch, cool off, and dry clothes. There are generally three types of balconies: cantilevered, recessed, and corner.

  2. Anonymous users2024-01-22

    In general, at 1000 1200 1500 1800 2000 Pillars will be added to the outside1

  3. Anonymous users2024-01-21

    The standard width is 1 meter or greater.

Related questions
1 answers2024-01-28

The exterior balcony is structurally 1.8 meters tall.

As for how much reinforcement to use, you need to check and calculate the load of your outer balcony. I won't do the math, I'm sorry. >>>More

2 answers2024-01-28

I hope to change the design, but if you want to do it, you need to use cement above C40, and increase the height-width ratio of the beam

1 answers2024-01-28

The protruding pick is OK The pile is very good with 6 16 (for the consideration of adding layers in the future) Since the column is a structural column, 4 14 are on the line of the beam, and the bottom three 16 are on the top two with 14 The beam should be reinforced!

1 answers2024-01-28

Do you mean the location of the balcony? You see what it says in the atlas. There are on 03 and there are on 09. It's available on a lot of atlases. 18 load-bearing walls are affordable.

2 answers2024-01-28

The balcony beam slab is an integral cast-in-situ or a prefabricated slab on the beam, because the balcony beam slab is an integral cast-in-situ force in the short side direction, and the prefabricated slab on the beam is stressed in the long side direction. The calculation method of the structure is different depending on the direction of the force. Please add clarity.