How to deal with water seepage in the bathroom? Do you have to knock off the tiles

How to deal with water seepage in the bathroom? Do you have to knock off the tiles

How to deal with water seepage in the bathroom? Do you have to knock off the tiles、:

In this case, it is difficult to deal with it, because the main reason for this leakage is that the waterproof layer has been destroyed, we need to redo the waterproof layer, it is a pity to smash the tiles, we use the following waterproof methods to deal with it: (1) Find the leakage point, use water leakage blocking: the common leakage part is around the pipe mouth, if it is determined that the leakage occurs around the pipe mouth, we can use waterproof materials such as water leakage to plug the leakage to solve the problem.

2) grouting waterproofing from downstairs to the ceiling: use the grouting machine to pump the polymer polyurethane grouting material into the concrete internal expansion and stop dry water, fill the concrete void to achieve the purpose of waterproofing, this method can be solved from downstairs without destroying the tile, but the ceiling of the downstairs ceiling needs to be removed, and the building must be a concrete pouring structure. (3) Use waterproof rough rent caulk to fill the gaps in the tiles

Clean up the gaps of the tiles, and then use waterproof caulk materials to fill the gaps of the tiles, because the water permeability of the rock eggplant is very low for the tile itself, if the ceramic tile with glaze on the surface will not be permeable, the general water seepage is infiltrated from the tile gap, so as long as the tile gap is completely blocked, the water leakage problem can be basically solved.

1. If the bathroom water pipe is leaking, the tiles at the leaking place should be smashed off, and the pipe should be repaired by hot melting; 2. The waterproof layer of the bathroom is slightly leaking, do not knock off the tiles, you can use the brick-free waterproof material according to the product manual to repair it; 3. The waterproof layer is seriously leaking, so you need to smash the tiles off and redo the waterproofing.

1.First of all, the bathroom is closed, and then observed, the waterproof and closed water test is best to reach 48 hours, and the water should be put three centimeters high when the water is closed, and then go to the downstairs residents' bathroom to check whether there is water leakage to be safe.

: If there are no obvious traces of leakage downstairs during the process of closing the water, it means that there is a problem with the water pipe.

: If the water level drops when the water is closed, and the leakage downstairs is serious, it means that the waterproof layer is a problem.

2.If there is a problem with the water pipe, we first consider whether it is because the floor drain is not installed in place, because if the floor drain is not connected to the sewer pipe, there will be a gap in the middle, and the toilet water will slowly seep down in the gap, and after a long time of accumulation, there will be water leakage.

3.Observe the angle valves, showers and other bathroom products in the bathroom, if the installation is not in place, there will be water seepage, and after a long time of accumulation, there will be water leakage.

1.The problem of toilet leakage can be large or small, if the waterproof layer of the bathroom is damaged and there is water leakage, then when repairing, as long as this part is repaired, but if the bathroom leakage is serious, and it is also an area of water leakage, then when repairing, it may be necessary to remove the floor of the entire bathroom and redo the waterproof layer.

If the waterproof layer is broken and the water leakage is broken, the repair method will be relatively simple.

The first is to stop using the water source in the bathroom for a few days and keep the bathroom properly ventilated, so that some residual water stains will evaporate, and after the floor of our bathroom is dry

Penetrating waterproofing agent, repair the cracks, and then use it to brush the gaps in the tiles, floor drains, and around the pipes, and brush them continuously 2-3 times, without intervals in between.

Gel-type waterproof material, mix with water, pour it to the bathroom floor, it will automatically find cracks, form a gel, and achieve the purpose of waterproof leakage.

Crystal porcelain waterproof material, AB two-component ratio is good, stir for 3 minutes, first brush the tile gaps, floor drains, around the pipe, and then brush the large surface 1 time, dry on the surface to form a transparent protective film.

2.If the bathroom is a waterproof layer leakage, then the maintenance may need to replace the new waterproof layer, but also knock off the original tiles, the specific cost is related to the area, the size of the bathroom area, the later maintenance, we must pay attention to the waterproof must choose good quality, otherwise the later leakage will be troublesome.

If the bathroom is leaking, then the waterproofing is not done, then you must open the tile to him, so that you can redo the waterproofing, otherwise you have no way to get it.

No need to knock on the tiles.

1. Deal with the dust, oil, and stagnant water on the surface, and keep the surface dry 2. Block the floor drains in your bathroom and seal them to prevent water from flowing into themApply the proportional waterproof coating material evenly to the floor, ventilate it for a few hours, and clean it up when the floor is completely dry.

Water seepage indicates that there is a problem with the water pipe or whether it is a leak upstairs, and it is necessary to open the tiles to find the water outlet point in order to repair it thoroughly.

How to deal with toilet seepage? I think if there is water leaking in the bathroom, the first thing to do is to knock off the tiles and see where the water is leaking. Wipe the leak with cement.

I do it under waterproofing. I don't miss it later. Reattaching the tiles again will do it.

There are two main reasons for water seepage in the bathroom: one is that the waterproof layer of the bathroom is not done well, and the other is that the floor drain in the bathroom is blocked, causing water to leak out of the heating pipe casing.

1. In the first case, if the waterproof layer is not done well and there is a large area of water seepage, it is necessary to knock off the bathroom floor tiles and re-do the waterproofing.

2. In the second case, the height of the casing of the heating pipe out of the ground is not enough, and there is a gap between the heating pipe and the casing, which needs to be filled and smoothed with putty. Of course, try to avoid blockage of floor drains.

It is not necessary to knock off the tiles. Now there is a waterproofing material that can be waterproofed without knocking off the tiles.

You have to knock off the tiles and find the leak!

To have a good effect and waterproofing thoroughly, it is recommended to knock off the floor tiles.

1. Brush the waterproof paint for the first time. Before construction, ensure that the construction site is clean and dry, and the waterproof coating should be coated with no omission, firmly combined with the base layer, no cracks, no bubbles, and no falling off. The coating height is consistent, and the thickness should meet the requirements of the product.

2. Brush the waterproof paint for the second time. Note that there needs to be a certain time interval between the second waterproof coatings, and the second pass can only be carried out after the paint is dry, and the specific time depends on the coating.

If you want to eliminate the leakage of the water pipe, you can use invisible waterproof technology to do it without knocking bricks.

Look for the leakage, the general monopoly waterproof shop has to undertake, there is no need to knock on the tiles, the repair is basically not leaked, unless the house has sunken new cracks, but the price of the leakage depends on whether the master is black or not, this has no market price, because there are few things, so the price is high, you first find a professional leak repair master to see the situation, you can make up you can not knock. I have helped my master to fill in the gaps for more than 10 years, but I haven't found anything that can't be filled.

If you want to do it once and for all, you have to remove the tiles, re-waterproof, and then re-put the tiles on them. If you don't want to peel off the tiles, use the plugging spirit or something, that is, temporarily manage things, and after a long time, it will leak if it is not even.

1. If the bathroom water pipe is leaking, the tiles at the leakage should be smashed off, and the pipeline should be repaired by means of hot hole melting; 2. The waterproof layer of the bathroom is slightly leaking, do not knock off the tiles, you can use the brick-free waterproof material according to the product manual to repair it; 3. The water layer of the anti-trembling eggplant leaks seriously, and the tiles need to be smashed off and waterproofed again.