Is a solid wood ceiling good?

Now there are many kinds of ceiling materials, such as solid wood, integrated ceiling, gypsum board ceiling grinding hole, PVC ceiling, etc., each ceiling has its own advantages and disadvantages, the use of space is not the same, solid wood ceiling is more suitable for bedroom or sauna. Let's take a look at the construction process of solid wood ceilings.

Ceiling construction process: pay-off, determine the hanging point, install the wooden keel, level the side keel, level the overall leveling, arching, install the solid wood veneer adjustment.

Control points: 1) Pay-off.

2) The overall adjustment of the keel.

3) Install leveling. （2）

Precautions: 1) The ceiling is uneven. 2) The seams are obvious. 3) The ceiling is not properly connected with the equipment. （3）

Measures: 1) The error of the bullet elevation line is 5mm, and a control point should be added in the middle of a large area, and the line should be pulled through with the same section, and the line can not be sunk, and another hanging point should be set up for heavy equipment. 2) Accurate blanking and smooth corners. 3) The size of the reserved equipment port is correct, the closing mouth is straight and flat, and it is warped.

Acceptance evaluation criteria: 1).

The installation quality of the panel should meet the following requirements: meet the requirements of the design blind and dry drying, and the plate surface arching is accurate; The surface is smooth, the seams, interfaces, and plate seams are straight, without misalignment, and the width is consistent; The yin and yang corners are square; The shoulder angle and cutting direction of the decorative line are correct; The seam is tight, and the discharge position of the special-shaped plate is reasonable and beautiful. (Observation, line pulling, ruler inspection) 2).

The gold surface should meet the following requirements: the surface is neat and tidy, without warping and bruising. 3)

Allowable deviation and inspection method of ceiling engineering: item item allowable deviation (mm) inspection method 1: surface smoothness, check with 2m ruler and wedge-shaped feeler gauge, check 2, seam straight, use 5m line (less than 5m to find through line), check 3 points grid line straight, 1 use 5m line (less than 5m to find through line), ruler to check 4, seam height difference, use ruler and wedge feeler gauge to check 5, pressure strip spacing 2, use ruler to check 6, closing line elevation difference 2, use level or ruler to check.

The above is the sharing of solid wood ceilings, I believe you already have a general understanding of solid wood ceilings. If it is a bathroom and kitchen, it is not suitable for solid wood ceilings, and it is better to do integrated ceilings.

Look where it is used, the general living room and bedroom with solid wood are good, but the bathroom and kitchen are not very good, because the bathroom bath will be more humid, the kitchen smoke is relatively large, these are easy to deform the keel, so the bathroom kitchen ceiling is recommended to use light steel keel, aluminum gusset or PVC board to make the ceiling, living room and bedroom and the like with solid wood.

Modern style is best not to use solid wood ceilings, with a little fashionable to suit your home in the style.

It's not good, the cost is high, it's a long time, and it's not as good as a gypsum board ceiling.