What to do if the drain in the hotel kitchen is blocked

Updated on Kitchen 2024-01-28
5 answers
  1. Anonymous users2024-01-23

    Solving the blockage is very simple, rinsing with hot water, buying dredging agents.

    But the problem is mainly to solve the problem fundamentally, this time to solve the oil blockage, next time it will be blocked.

    First of all, the kitchen teacher in the restaurant is blocked, and you should discharge the untreated oil residue and garbage directly into the kitchen drain.

    Oil residue, garbage directly discharged into the sewer has a great impact, with the decrease of temperature, waste grease condenses, grease adheres to the inner wall of the drain pipe, and the inner diameter of the drain pipe decreases over time, resulting in unsmooth drainage to form a blockage, drainage inspection well wastewater overflows, summer wastewater breeds mosquitoes and flies, infectious diseases, and pollutes the environment with peculiar smells.

    It is recommended to install an oil-water separation equipment, waste residue, waste oil, and waste water are discharged separately, which is conducive to improving the environmental sanitation of the kitchen, and can also be inspected by the environmental protection department.

    The size of the oil-water separation equipment mainly depends on the size of the hotel, the price is not very expensive, and the ordinary stainless steel grease trap has no operating costs, so there is no need to worry about additional electricity costs.

  2. Anonymous users2024-01-22

    Buy a 2-meter pipe dredger, make some twists and turns at the head 2 cm, while releasing water, extend the dredge into the water outlet, stretch it in while shaking, and then extend it into the dredge at the water inlet while releasing water, repeat a few times. Or find a diameter of millimeters of wire, 3-4 meters long, half from the center, and then twist into a strand, and then bend the two heads in different directions at the single end, and then stretch this end into the sewer pipe, catch the other end, while going in and along the side of the twist in one direction some debris can be hooked out, repeat a few times can basically dredge, if your wire hook can not get something, it is dredged.

  3. Anonymous users2024-01-21

    It is to use a wet rag to roll into a roll to plug the floor drain first, and then use an air pump to pump the air from the sink to the air, and also use a rag to roll the air outlet pipe of the air pump into a thickness that is suitable for the water outlet of the pool to prevent air leakage.

  4. Anonymous users2024-01-20

    Open it to repair it yourself or find someone to spend money to repair it, and you must pay attention when you use it, and you can't let things block.

  5. Anonymous users2024-01-19

    You can open the lid under the water pipe and clean it up.

Related questions
14 answers2024-01-28

What should I do if the sewer is blocked? It can be used with a spring-loaded pull hook, with a turning spiral, built-in spring, and easy handling of soft materials.

10 answers2024-01-28

1. If the kitchen sewer is blocked by grease stains, you can prepare a basin of boiling water and pour it into the sewer pipe, which can effectively melt the oil stain on the pipe wall, so as to dredge the effect of waxing fruit. >>>More

6 answers2024-01-28

Clause.

1. Usually, the clogged sink is mostly due to the accumulation of debris at the U-shaped bend of the sewer pipe, resulting in poor drainage. If it is a sewer pipe with a sewage screw, remove it directly (to prevent staining the cabinet, it is best to pad a sewage basin at the bottom), after removing, dredge it with iron wire and steel wire, and it should be able to solve it smoothly. If it has not been solved, it may be necessary to remove all the sewer pipes, remove all the plastic connections, rinse them, and reassemble them, which I believe will not take more than 30 minutes to complete. >>>More

10 answers2024-01-28

What should I do if the sewer is blocked? It can be used with a spring-loaded pull hook, with a turning spiral, built-in spring, and easy handling of soft materials.

5 answers2024-01-28

Hello, I am sorting out the answer according to your question, please wait a while When the weather is cold, we can use hot water to scald the pipe about once a week, but it should be noted that do not use water that is too high temperature to scald, so as not to deform the pipeline, so as to effectively prevent the blockage of the pipeline, or even avoid the blockage of the pipeline.