What should I do if there is water seeping all the time next to the bathroom water pipe

Bathroom leakage is the first thing to determine where the water leaks. Generally, there are the following water leaks:

1. The leakage of the waterproof layer is manifested in the serious leakage downstairs after bathing or using water on the ground, and the downstairs performance may be one or more places. The judgment method is very simple, plug the floor drain, and then release water on the ground, pay attention to the observation of the water leakage downstairs after 40 minutes, if the water leakage downstairs is serious, it is determined that the waterproof layer is leaking. In this case, you can find 100 million waterproofs on the Internet, and you can repair them by using 100 million waterproofing agents, caulking paste, and plastic steel mud.

That is, the surface of the bathroom is waterproofed again, without planing tiles, saving time and cost.

Do you remove the old-fashioned squatting toilet when you make waterproofing during the renovation process? According to you, it should be the seepage caused by the squatting urinal.

Leakage, squatting toilet leakage is more likely, one is the leakage of the water inlet, especially when flushing, and the other is not connected with the sewer pipe.

Well, cause a water leak.

To summarize with reference to your characteristics above, there is definitely something wrong with the waterproofing of the squatting toilet drain, so I can say this, whatever the reason.

The leakage caused by it cannot be solved from the surface, and the most fundamental solution is to disassemble the pit, find the leakage point, and use the plugging spirit (east.

Haipai) carefully treat the pipe mouth to completely cure the problem of water leakage. Before that, I suggest you do a little experiment, you check if the pipe roots downstairs are still wet? Then you stop using the squatting stool and check again in two days to see if there is still leakage.

If there is still this problem, it is not simply a problem of squatting, you should consider it from other aspects, such as whether it is drenched.

The water of the bath seeps into the pit along the tile, then you can refer to the method mentioned by the friend above, and put the sealant on the dark corner of the ground, especially with squatting.

Toilet connected to the ground.

Guoerjia waterproof pointed out that there are two main reasons for bathroom leakage, one is that there is a leak in its own waterway, and second, the top layer of waterproofing is not qualified. You can ask the master to check whether the sewer pipe is not tightly closed, focusing on the water pipe of the basin and toilet, and the workers may damage these two places if they do not pay attention during the decoration.

Test whether the water inlet pipe is leaking.

1. If it keeps dripping, turn off the main gate first, and open all the faucets at home to drain all the water in the water pipe, and then turn off the faucet.

2. After confirming that the dripping water downstairs has stopped, open the main gate again, and do not use any water for half a day or a whole day after two or three hours.

3. If there is a drop of water downstairs, it means that the inlet pipe is leaking, and if it is not dripping for more than a day, it means that it should not be a leak in the inlet pipe.

Second, the drain pipe leakage test Find a soft water pipe with one end connected to the faucet, one end to the floor drain flush, insist on more than half an hour, to see if there will be water leakage downstairs.

Guoerjia waterproof company made a summary: bathroom leakage is really a problem that annoys everyone, affecting their own lives, and it may also affect other people's speech and destroy the neighborhood relationship because the water leaks downstairs. However, knowing the cause of the toilet building water and the maintenance method, I hope that when you encounter this troublesome problem, it can be helpful to you.

Note: The duration of the closed water test shall not be less than 48 hours, and attention should be paid to observe whether there is water seepage on the roof downstairs.

Step 1 There are two main reasons for the leakage of the bathroom, one is that there is a leak in the waterway of one's own house, and the other is that the top layer of waterproofing is not qualified. You can ask the master to check whether the sewer pipe is not tightly closed, focusing on the water pipe of the basin and toilet, and the workers may damage these two places if they do not pay attention during the decoration. 2. Test whether the water inlet pipe is leaking 1. If it is constantly dripping, turn off the main gate first, and open all the faucets at home to drain all the water in the pipe, and then close the faucet.

Note: Do not use any water after two or three hours for half a day or a full day. 2. After confirming that the dripping water downstairs has stopped, open the main gate again, and do not use any water for half a day or a whole day after two or three hours.

3. If the water is dripping downstairs, it means that the inlet pipe is leaking, if it is not dripping for more than a day, it means that it should not be the water inlet pipe leakage 3. Test whether the drainage pipe is leaking Find a soft water pipe with one end connected to the faucet, one end to the floor drain to flush, insist on more than half an hour, and see if there will be water leakage downstairs. (Note: Do not let any water flow outside the floor drain at this time, so that you can accurately test if there is a drain leaking problem.)

If it is a leaking water pipe, there is no good solution but to dig it up. If it is only the waterproof layer of the bathroom or the surface leakage, there is no need to dig it up, as long as the surface of the bathroom is treated to a drip. Summary:

Bathroom leakage is really a problem that annoys everyone, affecting their own lives, and it may also affect other people's speech and destroy the neighborhood because of the water leaking downstairs. However, knowing the cause of the toilet building water and the maintenance method, I hope that when you encounter this troublesome problem, it can be helpful to you. Note: The duration of the closed water test shall not be less than 48 hours, and attention should be paid to observe whether there is water seepage on the roof downstairs.

Turn the valve off and get a plumber to fix it.

There has been water seepage next to the bathroom water pipe, which is a leakage of the water pipe, although it is not serious, it will become more and more serious, and the leakage will be more and more, so there will be no water seepage if the water pipe needs to be replaced.

It may be that there is a crack in the water pipe inside, so you can find someone to repair it, otherwise the problem will get worse and worse.

I chiseled it open and reprocessed it.

Summary. Wrap it in sealing tape.

Wrap it in sealing tape.

Seal the ground with cement.

Leakage of water on the edge of the pipe in the whitish place.

This is the restroom on the upper floor.

Are you guys professional?

Summary. Hello! Pro, the solution to the water seepage next to the bathroom water pipe is as follows:

1. If the waterproof layer is seeping, you can use waterproofing agent to fill the gap of the waterproof layer that will leak, and then use plastic steel mud to fill it. 2. If the leakage is caused by the backflow of toilet sewage, the gap between the sewage pipe and the joint layer can be sealed with a plugging spirit. 3. If it is surface water infiltration, use caulking agent to plug the leakage.

There is water on the outer wall of the sewer.

Hello! Pro, the solution to the water seepage next to the bathroom water pipe is as follows: 1. If the waterproof layer is infiltrated and excavated, you can use waterproofing agent to fill the gap of the waterproof layer that will leak, and then use plastic steel mud to fill it.

2. If the toilet sewage is poured and irrigated and causes leakage, the gap between the sewage pipe and the joint layer can be sealed with a plugging spirit. 3. If it is surface water infiltration, it is okay to use caulking agent to plug the leakage.

Hello! Pro, the solution to the water on the outer wall of the bathroom sewer hand is as follows: 1. First of all, the tiles around the sewer pipe should be warped and the surrounding dirt should be cleaned up.

2. Apply an appropriate amount of plugging spirit around the pipe, and it needs to be smooth. 3. Apply waterproof mortar three times on the surface of Bichong, and each time must wait for the last time to be thoroughly dried before continuing construction. 4. After the construction is completed, the closed water test should be done on the ground to ensure that there will be no water seepage, and new tiles can be laid around the toilet sewer pipe.

Dear, if you find water seepage around the toilet sewer, it is recommended that you ask a professional to help you fill the leak, so as to avoid the problem of water leakage is more serious.