How to repair cracks in kitchen artificial stone?

Inflatity is the main problem, and there are fewer high temperature factors. Solution

1. Use an artificial stone slab of appropriate size and paste and reinforce it with stone glue below to prevent further deterioration and facilitate the next operation.

2. Use an angle grinder to cut along the gap, and the natural gap of the width of the stone saw blade can be. It is best to cut the 12-thick countertop thoroughly, and if it is not easy to master, it should not be less than two-thirds deep.

3. Fill the caulking with white marble glue and slightly higher than the countertop. After a little drying (don't wait for it to solidify completely) use a putty knife to trim off excess marble gum, especially on countertops except for crevices.

4. After the glue is completely solidified, it can be polished and polished.

It is necessary to find a professional to do it.

It is best to cut the 12-thick countertop thoroughly, and if it is not easy to master, it should not be less than two-thirds deep. x0d x0a3, caulk with white marble glue, and slightly higher than the countertop. After a little drying (don't wait for it to solidify completely) use a putty knife to trim off excess marble gum, especially on countertops except for crevices.

It is possible to repair, but it will not last long after repair, and it will still crack from its original position after a period of time;

Materials required: 1. Buy marble glue in building materials hardware stores, also known as Hercules glue, and buy some toner according to the color of artificial stone (he understands when he talks to the shopkeeper to adjust the color); The function of toner is to blend the color of marble glue into a color close to that of the stone, so that it can look beautiful.

2. Utility knife, batch ash knife.

2. Open the marble glue (component A), generally canned or barreled, find a piece of iron sheet or waste tile and other items, take out an appropriate amount of marble glue, add an appropriate amount of curing agent (component B), the general ratio is about 50:1, and then add toner, quickly stir evenly with a batch ash knife, pay attention to how much toner is added according to the color of the colloid, and the specific color of artificial stone shall prevail;

3. Apply marble glue to the cracks, wait for 3 to 5 minutes for the colloid to not stick to your hands, and use a utility knife to remove the leaking colloidal on the board surface;

4. After the countertop is repaired, wait for 2-3 hours before it can be used normally.

Find an artificial stone supplier to repair it with a special glue and polish it, and the cracks are gone.

Schematic diagram of artificial stone countertop cracking: arc-shaped irregular cracking.

The first step is to drill holes at the end of the cracking (to prevent the table from continuing to extend and crack); Note: If there is a crack in the middle, holes at both ends are required.

Step 2: The jigsaw is grooved and cut directly through the countertop.

Step 3: Grind the artificial stone cylindrical shape to fill the round hole.

Step 4: Make the incision cuttings.

Step 5: Reinforcement on the back to prevent secondary cracking and prevent glue leakage.

Step 6: Glue filling.

Step 7: Cut the cuttings in order and make them even, keep the cuttings clean (try to avoid glue lines) Step 8: Polishing and polishing after the glue is completely dry.