Is it better to use acid or alkali to clean the toilet?

Updated on Toilets 2024-01-28
6 answers
  1. Anonymous users2024-01-23

    The dirt in the toilet is alkaline dirt, so he needs an acidic detergent to clean it completely, and the dirt in the kitchen is mostly grease and dirt, so it must be alkaline to completely remove the dirt. The whole is a physical process of acid-base action!

  2. Anonymous users2024-01-22

    Greater than 7 is a base, less than 7 is an acid, and equal to 7 is neutral.

  3. Anonymous users2024-01-21

    It's all right. For example, toilet cleaner and 84 disinfectant can be used, but do not use them together, it is very dangerous to use them together to produce toxic gases. Avoid!

  4. Anonymous users2024-01-20

    Use acid, most bacteria and viruses are not resistant to strong acids!

  5. Anonymous users2024-01-19

    The dirt in the toilet is alkaline, and the dirt is good with alkali.

  6. Anonymous users2024-01-18

    Good alkalinity.

    1. Animal fat blockage: If it is oily, it is recommended to use boiling water, of course, if you can buy concentrated sulfuric acid, the effect is better. If something is clogged, the only thing you have to do is clean the pipes like the one you said upstairs.

    2. Cement plugging: 70% hydrochloric acid cannot be found, and 35 are sold everywhere, you can try it. Add a small amount of flour to it to act as a corrosion inhibitor, and it is best to have urotropine. It can reduce the corrosion of steel.

    3. Go to the market to spend quick money to buy a 2-meter-long spring wire pipe dredging tool, bend 1-20 degrees at 1-2 cm on its head, dredge it back and forth at the entrance and exit of the sewer, and flush it with water.

    2. The best way is to call the housekeeper to get rid of the disease.

    3. If it is oily, you can use 20 Su Fangda water to get through. If it's something blocked, you can only use special tools.

    4. The simple method is as follows:

    1).Flush into the waterway with a large pot of boiling water.

    2).Then poke it with a thick iron wire several times until the boiling water runs out.

Related questions
15 answers2024-01-28

First, choose tiles with low water absorption, generally speaking, high-quality tiles have very low water absorption, so that they can dry quickly. If the tile does not indicate the water absorption, you can use tea or water droplets on the back of the tile, and check the diffusion degree of the water droplets after a few minutes. Tiles with high water absorption rate will be cracked on the surface of the tiles and peeling off the entire wall and floor tiles after thermal expansion and contraction. >>>More

2 answers2024-01-28

Lamp warm bath bomb.

The lamp bath bomb uses the heat radiation of the bulb to raise the temperature, so its advantage is that the temperature rises quickly, and the power consumption ratio. >>>More

1 answers2024-01-28

Hello! As an industry insider, I recommend that you buy sandalwood, the grain of sandalwood is more beautiful than that of acid branches, and secondly, the feel after polishing is better. >>>More

3 answers2024-01-28

It must be non-slip, and what brand depends on your own preferences. Too much. As for the specifications, it depends on the size of your home, if it is large, it is generally 300*450 for large-size walls, and there are 300*300 floor tiles on the ground, and the cheapest price is 5-7 yuan per piece. >>>More

2 answers2024-01-28

Is it a leather sofa?

Detergents can only clean a certain range of stains, depending on what your sofa is soiled with >>>More