How to draw the ceiling diagram in CAD, the dimensions are? Detailed

1. Open CAD and find.

bai to the flat layout we have drawn.

2. Open zhi

The original top drawing, the DAO position and high return of the analysis amount, and the answer scheme of the ceiling shape is obtained.

3. Draw the modeling diagram of the living room first, a house living room is the key, and use gypsum board to suspend the ceiling.

4. Gypsum board ceiling in the aisle drawing.

5. Next, draw the integrated ceiling of the bathroom and kitchen.

6. Finally, the ceiling shape of the bedroom is determined, and the second bedroom only leaves the air outlet of the central air conditioner.

7. At this point, the ceiling of each space has been drawn. Finally, make a copy of the drawn ceiling map and mark the dimensions of each place.

1. Use the Rectangle tool to draw a rectangle, leaving a space on the left here to come out and show the curtains.

Second, as shown in the figure below.

The version is from the gallery copy right curtain here.

3. Offset a rectangle, defined by yourself here, which can be defined as 400 mm, and where cyan is represented as gypsum board.

Fourth, then draw the light strip, here the red table is not the light strip.

Fifth, put the headlights here again. As soon as you enter the door, you will see this headlight, and it will show that it is more luxurious.

Sixth, copy the copper lamp from the gallery again.

7. Draw the following picture, which has three diamonds, and the square is drawn here with the rotation tool. After copying some copper lamps came over and it was done.

8. The ceiling diagram of the living room is completed as shown in the figure below.

1. Use the bai rectangle tool to draw a rectangle, leaving a space on the left side to show the curtains.

of the DAO. 2. As shown in the figure below, copy the curtain from the back gallery to the answer.

3. In the offset of a rectangle, here you define yourself, you can define it as 400 mm, here cyan is represented as gypsum board.

4. In the process of drawing the light strip, here the red table is not the light strip.

5. Put the headlights here. As soon as you enter the door, you will see this headlight, and it will show that it is more luxurious.

6. Copy the copper lamp from the gallery.

7. In the following picture, there are three diamonds, and the square here is made with the rotation tool. After copying some copper lamps to complete the picture below.

8. The ceiling of the living room is completed as shown in the figure below.

1. Use the rectangle tool to draw a rectangular source, and leave a space on the left to see the curtains. du

2. Copy the zhi curtain in the gallery on the left

Edge area. 3. In the offset of a rectangle, here you define yourself, you can define it as 400 mm, here cyan is represented as gypsum board.

4. In the process of drawing the light strip, here the red table is not the light strip.

5. Put the headlights here. As soon as you enter the door, you will see this headlight, and it will show that it is more luxurious.

6. Copy the copper lamp in the gallery.

7. Draw three squares and use the rotation tool to make a diamond, and copy three copper lamps in the diamond to complete the ceiling.

Interior Design Construction Drawings CAD Ceiling Material, Size, Elevation Deduction.

It is generally 20 cm high from the top of the wall, 30 or 35 cm wide from the wall, and a few are 40 cm. The width of the outer baffle of the light trough baffle is generally 8 cm, and the width of the light trough is 10 cm or 12 or 15, which is determined according to the width of your entire ceiling. I'm doing engineering, so I don't know how to draw the diagram! Hehe!