What to do if water seeps from the top of the balcony?

This may be a little troublesome, will not simply repair the cracking of the outer decoration layer can be solved so simply, to dig to the strong part of the wall to deal with, waterproof coating to coat a larger area, more information, better advice, free concrete waterproof leakage repair technical advice, to avoid today's repair, tomorrow's leakage, every year repair, every year leakage of trouble.

The balcony is waterproofed, and this problem cannot be solved without waterproofing.

Answer 1: If the upstairs waterproofing is not done well when the balcony roof leaks, you can contact the upstairs owner to re-do the waterproofing. When re-doing waterproofing, we must first knock off the floor tiles on the ground, clean up the base layer, and then paint the waterproof paint twice as required.

2. When we decorate the house, we will go to the top of the water pipe, and then cover it with the ceiling, and the water pipe is damaged and leaking, which is also a cause of balcony leakage. When we repair the water pipe, we must first use a suction cup to remove the aluminum gusset at the leakage of the ceiling, and after finding the leaking pipe, we will cut the damaged water pipe and repair the pipe through PVC glue or hot melt connection. If it is caused by a water leak from the upper and lower floors, we can contact the upstairs neighbor for repairs.

Find the upstairs occupants.

Question: The living room has a bag on the roof.

The question is that the living room is generally not waterproof.

You belong to the cracking of the exterior wall causing water seepage in, which is very troublesome. Simple, please professionally waterproof directly on the outside with plugging king. If it's troublesome, knock off the exterior wall tiles along the cracks (including the cement part below) and let the bricklayer re-use cement mortar to flatten it, and then do waterproofing and then paste the tiles after drying.

The glass glue is directly sealed. No, you can just get the water out of the canopy.

First clean up all the original filling, close it with a small amount of expansion glue, close it again with plugging spirit on the surface, and close it again with sealant for all sealants, it's almost the same.

First cut a crack in the outer window that is 1 cm wide and 1.5 cm deep, and then clean it and sprinkle some water to soak it thoroughly. Fill it into putty with the plugging king, smooth it and sprinkle some water to prevent cracking after drying. After finishing, apply two to three more waterproofing paints, using the very flexible kind.

Processing steps: First, clean out all the original fills;

second, seal with a small amount of expansion glue;

Third, the surface is closed again with plugging spirit;

Fourth, all closures are closed again with sealant, taking care to do both inside and outside.

Here's how:

First of all, the balcony leakage should be found first, mainly from the high of the roof to the low place, because the water flows to the bottom.

Look at whether there are cracks in the roof, whether the original waterproof layer has aged off, and whether there are bubbles in the original waterproof membrane of the roof.

There is also whether the gutter on the roof is blocked, in the countryside, there are still a large number of tiled houses, when there is a roof leakage due to tile breakage, just replace the tile, this step is also called "leakage".

Secondly, if the roof is only the original waterproof, you only need to remove the leaking part 2 3cm deep and clean it, you use asphalt to water it, and now there is a finished asphalt coating film, and when it is sunny, it will basically not leak.

If there is a waterproof layer, it is more troublesome, to remove the waterproof within the surrounding area, re-do the waterproofing, and pay attention to the original waterproof junction to do a reinforcing layer.