-
If the water pipe in your home is leaking, you can use two pieces of iron to make a hoop, wrap it in rubber in the middle, and tighten it with screws. Also, when you go to the hardware store, there is a vacuum bag made of epoxy resin, (I forgot the name, but you can just ask the salesperson) and there are epoxy resins and bandages and the like, according to his instructions, after 24 hours of pressure resistance, your unit main line is fine.
-
First of all, you must turn off the main switch of the water pipe at home, otherwise it will be troublesome if the water leaks to someone else's house. Knock the tile, find the broken place, hot melt the ppR pipe with a hot melt gun, if it is an iron water pipe, go to the hardware and plumbing store to buy a quick catch of the same caliber, check to make sure that there is no leakage, and repair it with high-grade mortar masonry.
-
Close the water valve immediately.
Completely remove the damaged water pipe on the wall.
Replace the water pipes with new ones.
After the pressure test, open the water valve.
Because the water pressure of the tap water pipe is high, the position of the plugging and leakage is very poor, and it is best to replace it in time.
-
Tell me the size of your hole, preferably with a picture. I might be able to fix the leak without opening the tiles.
-
Smash bricks, other methods are not thorough.
-
Don't hesitate to dismantle the bricks and plane the walls and reweld them. Are you relieved to manage to deal with it outside?
Distinguish whether it is a water pipe that comes with the purchase of a house or a water pipe installed in the later decoration, if it is a house that comes with it, the property pipe during the warranty period, and the company is responsible for the later installation. >>>More
Èç¹AB½ºÄ
ç¹AB½ºÄ >>>More
1. Determine the drilling location. The first step in tile drilling is to find the correct drilling position, to try to avoid damaging the water and electricity lines when drilling, and to paste a tape on it, which is a very safe practice. >>>More
1. The best way is to use the fragments of the pipe, the decoration place is any point, to the same size of the pipe, its arc is the same, with the glue to glue the water pipe is very firm. >>>More
This is the 20 elbow of PPR, you need to cut off the PPR pipe, re-hot melt, there is no other way, because you take any glue, the tape is useless, maybe sealed, but it will not take long and it will leak, the gain outweighs the loss, so you have to smash the wall along the direction of the water pipe, expose the water pipe, and then cut off the PPR pipe, and take the fuser again. In fact, an elbow is about 2 yuan, but if you find someone to install, it will cost more than 2 yuan, because you also have to open the wall cracks, so I suggest that you have better smash the wall along the direction of the water pipe, and call a hydropower to pick it up, so that you can spend less money. I'm from Huai'an, and if you're here, I can help you out.